Brendon's '67 Firebird thread by Tuske427

2 minute(s) of a 286 minute read

Today I worked on chopping my old floor pans out getting the car ready to accept the replacement floor pans. MY subframe connectors are tacked in on the rear rails, but there isn't enough metal left in them to accept a continuos weld. They will need reinforcing, but I'll deal with that when my rear axle/ suspension shows up.

I removed the seat braces and was able to clean up the sides of the rocker panels. looks like my passenger panel may need more patches. I have also rough trimmed the floor pans to fit. They are close enough that I can start welding them in and final trim as needed.

I'll have the tops of the subframe connectors welded before install, as well as painting the bare metal with rust encapsulator.