1968 Firebird 400 by 68400BIRD

By diyauto
( 6 )

3 minute(s) of a 82 minute read

8-5-2009


I will try and post some more pics tonight. There not real picture worthy but I cut all the holes needed for the floor shifter and console. I didn't enjoy cutting holes in my newly installed floor. I also got the inside rockers painted and seam sealed. And one seat platform welded into place on the drivers side.


8-30-2009

Couple of pics with the car up in the air. Now it's time to get to work.






Couple of pics with the dash removed and the seat platforms welded in.




9-14-2009

Started working on the floor. The floor pan was scuffed and aprayed with DP90 about two weeks ago. I sandblasted for about six hours total on the back half. The inside of the trunk needed a good blasting. I found a few pin holes but they were not to hard to weld back up solid. The pictures of the trunk make it look a lot worse that it actually is. I got both of the wheel wells done up to the frame rails. Most of the dirty work is done on the bottom side.





Once the trunk is done I plan on tackling the front firewall. I spayed primer over some of the new front sheetmetal but the welds still need to be ground down. I bought the plate for smoothing the firewall since I am going with vintage air. Still not sure how I plan installing that yet.



Comments

Great car!

Posted by Diggymart on 1/23/21 @ 2:12:48 AM

Great car!

Posted by Diggymart on 1/23/21 @ 2:12:47 AM

Beautiful car and I loved the documented build from start to finish.

Posted by [email protected] on 9/5/16 @ 12:41:07 AM