You must be logged in to rate content!
2 minute(s) of a 92 minute read
10-15-2009
I made a bracket to hold the intercooler and it is in its new home. Now I can start planing the piping. I'm going modify to end tanks for sure.
10-18-2009
No sure, soon I hope.
I started building the intercooler piping for the car. I picked up 5 feet of straight 3 inch aluminum pipe and 2 slivers of solid 3 inch to cap the original intercooler inlets. I'm routing the pipe into the back of each end tank. I primarily used 15 degree cuts so that 2 put together the would equal 30 degrees. I did this in an attempt to keep the bends smoother. The u bend coming off of the turbo on the hot side of the intercooler is mild steel to accommodate the blow off valve flange that is steel. You will also notice in the pictures I got the rest off the exhaust installed. I also got the bumper cut and remounted.
