Silver_7's 94 RX-7 build by silver_7

3 minute(s) of a 122 minute read

Update 11/09/13: So did a few small things to the car on Saturday. Nothing major, just a few small things that have been bugging me for a while. Dale and I cleaned the front 99 spec rebar, installed manly horns from a Nissan Quest, wired the fog lights, cleaned the overspray off of the exhaust, installed the new exhaust tip, installed driver side fender liner and brake ducts. Also rolled the front and rear fenders.

Stripped the front bumper off of the car 

While the rebar was off...decided to give it a good cleaning

Cleaned up the 99 spec fog lights. We were able to find the connector in the junk yard off of another Mazda. 

Dale pulling the fender to blow out some dirt. 

While we were under the fenders...we took the time to clean up the wiring and re-tape them.

The lip on the front fender was slightly pulled down due to being so low and the tire hitting it, so we decided to roll the front and rear fenders.

Also went ahead and installed the fender liner and brake duct.

Continued.....

Stock horns on top. Manly Horns on the bottom from a Nissan Quest.

Took a little bit to line them up with the 99 spec bumper but we finally got them in place.

The exhaust had over spray on it from the previous owner. Dale had aircraft stripper to help take it off and clean it up.

All clean

New tip installed on the exhaust. 

All cleaned up and back together.