You must be logged in to rate content!
3 minute(s) of a 122 minute read
8-5-2013
8-5-2013
Update: Ordered a crap load of seals, vacuum hoses and other misc parts. Now for the wait. Still looking for a good condition rotor
8-7-2013
Finally received my first set of parts. Should have more coming in between now and Saturday to start putting the motor together.
Atkins Rotary: Gaskits, O-rings, rotor bearings and other misc seals and stuff
8-8-2013
More parts from Ray at Malloy Mazda. Gaskets, Hoses, AST delete and few other misc stuff.
8-12-2013
Update for 8/11/13: Dale did an amazing job on a lot of the parts that were there...looked almost new...lol. We cleaned and pained more parts including the engine bay. Cleaned up the engine harness and installed a few little things just to do it. Still waiting on more parts to show up this week so that hopefully we can start assembling the motor.
Installed the Banzai block off plates for emissions delete (No body have time for dat!!!)
Got some of the engine bay painted.
Painted the A/C compressor pulley. Was rusty and chipped all over.
Painted a few other misc parts and A/C lines
Wiring harness falling apart and needing some love.
Dale going through the harness...also deleted a few things we will no longer be using.
All cleaned up and pretty again
New windshield washer and coolant overflow tanks...the other ones were yellow and cracked.
Soon
Still waiting on more parts. If they all come in this week...we can start putting the motor together by the weekend. Fingers crossed.