You must be logged in to rate content!
2 minute(s) of a 36 minute read
12-12-2010
thanks!!
I jumped into it not knowing what the heck I was going to do, that's for sure!
slid the forks up in the clamp a little....it looks a bit better now I think...
12-20-2010
alright, I have decided to re-do the complete wiring harness on this thing.
I have had this diagram for a while, but it's a pain to follow
So i decided to sit down with visio for a bit to design something that I could follow just by a glance.
I THINK I have the regulator wired up right, IG gets 12V, makes sense to me since it needs juice to power the field windings....I think...
I know the starter switch originally switched the ground, but that will not be the case now.
1-27-2010
well, I still don't have a picture, wiring has been put to the side to get my new ride to daily status
it's good to go now, so between school and work I will be getting back to the bike...
simplified wiring will not be too dificult to get together...just have to figure out what I want o the bike!